Pro-Lift F-2525 Instrucciones De Funcionamiento Y Manual De Piezas página 4

OPERATION
Lifting
1. Follow the vehicle manufacturer's recommended guidelines for lifting. Engage the vehicle's emergency brake and
chock the unlifted wheels in both directions to prevent inadvertent movement.
2. Close the release valve by turning the pump handle clockwise until firm resistance is felt.
3. Center jack saddle under lift point.
4. Insert handle into handle sleeve and pump to contact lift point. Verify the lift point, then pump the handle until load
reaches desired height
5. Immediately transfer the load to appropriately rated jack stands.
Lowering
WARNING: Clear all tools and personnel before lowering vehicle. Open release valve slowly. The further the
!
pump handle is turned counter-clockwise, the faster the load will descend. Maintain control of load at all times.
1. Raise load high enough to clear the jack stands.
2. Remove jack stands.
3. Slowly turn the handle counter-clockwise, but no more than 1/2 full turn. If the load fails to lower:
a. Use another jack to raise the vehicle high enough to reinstall jack stands.
b. Remove the malfunctioning jack and then the jack stands.
c. Use the functioning jack to lower the vehicle.
4. After removing jack from under the vehicle, fully lower the saddle to reduce ram exposure to rust and contamination.
MAINTENANCE
NOTICE: Use premium quality hydraulic jack oil. Avoid mixing different types of fluid and NEVER use brake fluid,
turbine oil, transmission fluid, motor oil or glycerin. Improper fluid can cause premature failure of the jack and the
potential for sudden and immediate loss of load.
Adding oil
Correct oil level allows the saddle to reach its advertised maximum height and its advertised minimum height.
NOTICE: Too much oil will prevent saddle from lowering completely. Too little oil will not allow the saddle to raise
completely.
1. With saddle fully lowered set jack in its upright, level position. Remove oil filler plug.
2. Fill until oil nearly covers the inner cylinder as seen from the oil filler hole. Reinstall the oil filler plug.
Changing oil
For best performance and longest life, replace the complete fluid supply at least once per year.
1. With saddle fully lowered, remove the oil filler plug.
2. Lay the jack on its side and drain the fluid into a suitable container.
NOTICE: Dispose of hydraulic fluid in accordance with local environmental regulations.
3. Fill reservoir with proper amount of oil. Oil level will vary from just covering the ram cylinder to 3/16" above it as
seen from the oil filler hole.. Reinstall the oil filler plug.
4. Perform Bleeding/Venting Trapped Air procedure.
Lubrication
A periodic coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust and assure that
wheels, casters and pump assemblies move freely.
4