Mains Lead - Laney CUB HEAD Instrucciones De Operación

Tabla de contenido

Publicidad

10
15W INPUT: Plugging into this input uses the amplifier in full power mode.
<1W INPUT:
Plugging in to this input switches the output power stage down to around 1W. (Use this feature for
recording or bedroom playing).
11
SERIAL NO: Displays the model details and serial number of the unit
12
EXTENSION CABINET SOCKETS: One for use with an 8 ohm extension cabinet and one for use with a 16 Ohm
extension cabinet. Please note mismatched impedance will reduce the amplifiers performance and in some cases may
cause damage to your amplifier. Only use ONE of these outlets at a time. Try your CUB HEAD into a Laney CUB CAB
2x12" extension cabinet - you will be amazed!
13
MAINS LEAD: The mains lead is permanently attached so that it does not get lost or forgotten when you transport
your amp. Stow it in the straps provided when not in use to avoid damage.
14
EFFECTS LOOP: SEND/LINE OUT: Connect the input of your external effect to this socket. This is an insert type
control, therefore all of the signal leaves the amplifier via the `Send' socket to be processed. This socket can also be used
as a Line Level Out. (-10dBV Nominal)
15
EFFECTS LOOP: RETURN: Connect the output
from your external effects to this socket. The effects
loop allows you to connect external effects such as
tremolo, chorus and delay to your amplifier. (-10dBV
Nominal)
16
FOOTSWITCH SOCKET: Provided for the
connection of a Laney FS1 footswitch (optional) .This
allows you to remotely switch the built in Digital
Reverb On/Off.
17
HANDLE: Laney soft grip handle for comfortable
transportation.
(Always switch off and disconnect the power cord when not in use).
14 15
11
LZB1 2 3 4
12
13
16 17
11

Publicidad

Tabla de contenido
loading

Tabla de contenido