Cleaning And Care; Cleaning The Grease Filter - GUTMANN Campo II 05 EM Instrucciones De Uso

en

Cleaning and Care

Cleaning the Surface
Risk of Electrical Shock!
Separate the exhaust hood from the
electrical supply by removing the plug from
the outlet or tripping the fuse. Please make
sure that no water enters the device during
cleaning. Early cleaning of the surfaces
prevents toilsome removal of deep-rooted
debris later. Please only use standard
detergent or all purposes cleaners which
are suitable for stainless steel/aluminum
surfaces. Never use scouring cleaners or
steel wool.
After cleaning the hood, treat the stainless
steel surfaces with an appropriate preserving
agent. Painted surfaces should be cleaned
with a mild detergent and a very soft cloth.The
control panel must only be cleaned with a soft,
damp cloth.

Cleaning the Grease Filter

Risk of Fire!
The performance of the exhaust hood is
affected by greasy debris; the risk of fire
increases with the amount of deposits. In
order to prevent the risk of fire, regular
cleaning of the metal filter is recommended.
The necessity of cleaning the grease filter
is also displayed via the LED indicators: The
red LED on the ceiling device will begin to
light up after 15 hours of operation - when
this happen, please clean the filter. To do so,
first gently press the special glass pane
upwards with both hands.
The glass will slowly lift upwards and the
grease filter located beneath it can now be
removed. The metal filter is best cleaned in a
dishwasher with gentle dishwasher
detergent. The manufacturer offers no
guarantee in the event of possible
discoloration through the use of aggressive
cleaning products. Temperatures above 55
degrees should also be avoided. Attention:
Please do not use any 3 phase cleaners or
clean the filter in a commercial dishwasher.
Cleaning with aggressive products such as
benzene, acetone, trichloroethylene, et
cetera will lead to the destruction of the filter!
To replace the metal filter after cleaning, lift
the glass pane upwards again with both
hands and then held the switch to the right
for 10 seconds. The hours of operation
counter will be reset and the red LED will go
out.