RIDGID RD905712 Manual Del Operador página 18

ASSEMBLY
LOOSE PARTS LIST
See Figure 3.
The following items are included with the generator:
Key
No. Description
1 Axle Bolt ..............................................................2
2 Wheel ...................................................................2
3 Washer (5/8 in.) ....................................................2
4 Lock Nut ..............................................................2
5 Screw (1/4-20 x 2 in., Hex Hd.) ...........................4
6 Washer (1/4 in.) ....................................................6
7 Legs with Rubber Feet (Left and Right) ...............2
8 Nut (1/4-20, Self-Locking) ...................................6
9 Engine Lubricant..................................................1
Operator's Manual (not shown) ...........................1
TOOLS NEEDED
See Figure 4.
The following tools (not included or drawn to scale) are
needed for assembly:
 7/16 and 3/4 in. Socket Wrench
 7/16 in. and 8 and 10 mm Combination Wrench
NOTE: Do not put fuel or lubricant in the generator before
installing the legs and wheels.
INSTALLING LEGS
See Figure 5.
 Locate the following items:
Legs with rubber feet (left and right)
6 washers (1/4 in.)
6 lock nuts
4 screws (2 in.)
2 screws (1 in.)
 Raise the front end of the generator, where the engine is
located, high enough to gain access to the frame bottom;
securely position props underneath to support.
 Position a leg over the holes on each side of the frame
support. The tab on the leg should face the inside of the
Qty.
generator frame.
 Insert each 2 in. screw through a washer and insert the
screws through the two holes in the frame and the leg.
 Fasten the screws by installing a self-locking nut over
each screw on the inside of the frame. Tighten the nut
securely.
 Insert a 1 in. screw through a washer, the hole in the frame
crossbar, and then through the hole in the leg tab. Install
a self-locking nut and tighten to secure.
 Repeat with remaining leg.
INSTALLING THE WHEELS
See Figure 6.
Wheels are provided to assist in moving the generator to the
desired location and should be installed on the side opposite
the recoil starter.
 Locate the following items:
2 axle bolts
2 washers (5/8 in.)
2 lock nuts
2 wheels
 Raise the handle end of the generator high enough to
gain access to the frame bottom; securely position props
underneath to support.
 Place a washer on an axle bolt, then insert the axle bolt
through the center of the wheel.
 Place a washer on the axle bolt, then slide the axle bolt
through the bracket on the frame.
 Install lock nut and tighten to secure.
 Repeat the process on the other side to install second
wheel.
12 — English