Maintenance - Truper CEPEL-4-1/2NX Manual Del Usuario

Maintenance

WARNING
Disconnect the cable from the power
outlet before carrying out any adjustment, service or
maintenance to the tool.
Cleaning and Care
• Keep the tool dust-free. Never use water or chemical
substances to clean the tool. Use only a clean and dry
cloth.
• Always keep the ventilation slots clean and free of
obstructions to guarantee the adequate cooling of the
motor.
• Inspect regularly all the mounting screws. Make sure that
are tightly fastened. If a screw is loose, tighten immediately.
• The armature and motor are the power tool's heart. Use
extreme care not to affect the tool with oil or water.
• Double-check the power cable. Look for any type of
damage. If the cable is damaged take it to a
Authorized Service Center.
Service
• Servicing the tool shall only be carried out in a
Authorized Service Center. Service
and maintenance carried out by non-qualified people
may be dangerous and may cause personal injuries. It
also makes the Warranty void.
Carbon Brush Replacement
• Carbon Brushes should be periodically checked and
when worn, replaced always in a
Authorized Service Center.
• After replacing the carbon brushes request to inspect if
the new carbon brushes can move freely in the carbon
housing. Also request to run the tool 5 minutes to make
even the contact with the carbon brushes and the
commuter.
• Use only original
specifically designed with the hardness and resistance
adequate for each type of motor. Carbons that are out of
specification could damage the motor.
• Both carbons should be changed simultaneously.
spare carbons
9
ENGLISH