Power Connection; Care & Maintenence; Cleaning The Cleaner Compartment And Mesh Filter Plate - Kokido K900CBX Manual Del Propietário

Tap "ON/OFF" to power on; indicator light of mode used during last operation begins to
flash. Tap "CYCLE" button to select desired mode. Once the operation is finished, all 3
indicator lights will flash simultaneously.
Pool shape, water depth and pool floor are potential factors affecting the cleaner
moving in the pool. If your pool size is already the maximum size that the cleaner is
recommended for, select "L" mode, otherwise, select "M'' as the initial start. Observe
the cleaner is moving pattern and change to other selection if necessary. In addition,
make sure the nozzle setting is properly selected.
Note: When turning on power of cleaner, the operated mode used previously is
automatically selected.
CAUTION: Do not restart the cleaner immediately after stopping. Wait for at least 30
seconds before restarting.

Power connection

WARNING!
- The power cord must be connected to a receptacle protected by a residential current
device (RCD). Do not use an extension cord to connect the cleaner to an electric supply;
directly connect to a properly-located electric outlet. The Power Supply & Control unit
should be placed near the electric outlet.
- The Power Supply & Control unit should be placed in a dry, sheltered area at least 3.5
meters (11.5 feet) from the edge of the pool. The Power Supply & Control unit should
not be left exposed in the rain or placed in puddles of water. NEVER submerge this unit
in water.
- Check the power cord and cable for damages before initiating the operation. NEVER
operate the cleaner or Power Supply & Control unit if the power cord or cable is worn
or damaged. Locate the cord or cable to prevent it from being damaged by the lawn
movers, hedge trimmers and other equipment.
Prior to connecting the power supply to the cleaner, make sure the rated voltage and
frequency (hertz) of your electric outlet match the Power supply & control unit's
rated input voltage: 230VAC, frequency: 50Hz or 110VAC, frequency: 60Hz
Now, connect the plug to the electric outlet. Tap the On/Off button and select the cycle
mode to start the cleaning.
CARE & MAINTENANCE

Cleaning the cleaner compartment and mesh filter plate

WARNING!
Cease the operation of the cleaner and switch off the power before removing the
cleaner from the pool.
Caution
- The cleaner may become very heavy when filled with water.
14