power tool and application tools, keeping their hands warm,
and organising workflows correctly.
Assembly
Pull the plug out of the socket before carrying out any
u
work on the power tool.
Changing the tool
Wear protective gloves when changing tools. There is
u
a risk of injury when touching the application tools.
The following table shows examples of application tools. You can find additional application tools in Bosch's extensive range of
accessories.
Application tool
Bi-metal segment
saw blade
Sanding plate for
Delta series 93 mm
sanding sheets
Profile sander
Bi-metal plunge cut
saw blade for wood
and metal
HCS plunge cut
saw blade for wood
Bi-metal plunge cut
saw blade for hard-
wood
TC plunge cut saw
blade, metal
Bosch Power Tools
Selecting an Application Tool
Please observe the application tools intended for your power
tool.
Application tool
Material
Application
Wood-based materials,
Separating cuts and plunge saw cuts;
plastic, non-ferrous
including sawing close to edges, in corners and in difficult-
metals
to-reach areas;
example: Shortening skirting boards that are already in-
stalled or door frames, plunge cuts when adapting floor
panels
Depends on the sanding
Sanding surfaces at edges, in corners or in difficult-to-
sheet
reach areas;
depending on the sanding sheet, e.g. for sanding wood,
paint, varnish, stone;
fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnish, polishing felt for pre-
polishing
Wood, pipes/profiles,
Convenient and efficient sanding of profiles up to a dia-
paint, varnish, filler, metal
meter of 55 mm;
red sanding sheets for sanding wood, pipes/profiles, var-
nish, filler and metal
Softwood, soft plastics,
Small separating cuts and plunge cuts;
plasterboard, thin-walled
example: Cutting a recess for sockets, cutting a copper
aluminium profiles and
pipe so that it is flush with a surface, making plunge cuts in
non-ferrous metal pro-
plasterboard
files, thin sheet metal,
Delicate adaptation work in wood;
non-hardened nails and
example: Sawing recesses for locks and fittings
screws
Wood-based materials,
Separating cuts and plunge saw cuts;
soft plastics
including sawing close to edges, in corners and in difficult-
to-reach areas;
example: Thin plunge cut in solid wood for installing a
ventilation grille
Hardwood, laminated
Plunge cuts in laminated boards or hardwood;
boards
example: Installation of skylights
Metal, extremely abrasive
Plunge cuts in extremely abrasive materials or metal;
materials, fibreglass, plas-
example: Cutting kitchen front covers, easy cutting
terboard, cement-bonded
through hardened screws, nails and stainless steel
fibreboard
English | 17
PMF 250 CES
1 609 92A 675 | (02.02.2021)