Troubleshooting - Fulgor Milano FCLHD 9041 HID TS BK Instrucciones Para La Instalación Y Uso

TROUBLESHOOTING

Problem
You cannot activate or
operate the appliance.
The hob deactivates.
Residual heat indicator
does not come on.
Automatic Warm
function does
operate.
The heat setting changes
between two levels.
The sensor keys become
hot.
a 4
comes on.
comes on.
Possible cause
The appliance
connected to an electrical
supply or it is connected
incorrectly.
The fuse is released.
it's been more than 10
seconds from the switching
on of the appliance.
You touched 2 or more
sensor keys at the same
time.
Pause function operates.
There is water or fat stains
on the control panel.
You put something on the
sensor key ON-OFF.
The zone is not hot because
it operated only for a short
time.
Up The zone is hot.
not
The highest heat setting is
set.
Power
function operates.
The cookware is too large
or you put it too near to the
controls.
Safety Switch operates.
The Child Lock function
operates.
Remedy
is not Check if the appliance is correctly
connected to the electrical supply.
Refer to "Electrical connections "
chapter.
Make sure that the fuse is the
cause of the malfunction.
If the fuse releases again and again,
contact a qualified electrician.
Activate the appliance again and
set the heat setting in less than 10
seconds.
Touch only one sensor key.
Refer to "Using the cooktop"
chapter.
Clean the control panel.
Remove the object from the sensor
key.
If the zone operated sufficiently
long
Authorised Service Centre.
Let the zone become sufficiently
cool.
The highest heat setting has the
same power as the function.
Refer to "Using the cooktop"
management
chapter.
Put large cookware on the rear
zones if possible.
Deactivate the appliance and
activate it again.
Refer to "Using the cooktop"
chapter.
19
to be hot contact an