Cleaning And Care - Unold 87615 Manual De Instrucciones

attention: the appliance becomes very hot during operation. avoid direct skin contact. danger of burns!
1. Prepare your hair as described in the chapter
„Before first use".
2. Attention: your hair should be completely
dry before straightening. Straightening your
hair when it is still damp will damage your
hair. Therefore you should dry your hair well
using a hair dryer, if necessary.
3. Separate the combed hair into strands no
more than 5 cm wide. If necessary, separate
the strands using hair clips.
4. Check if the appliance is locked and unlock
it, if necessary.
5. Connect the plug to a wall socket (220 -
240 V~, 50 Hz).
6. Switch the appliance on pushing the button
EIN/AUS [ON/OFF] for two seconds.
7. The display lights up blue and the initial
temperature of 150 °C is indicated.
8. Adjust the desired temperature using the
buttons „+" and „-". The temperature can
be adjusted to 150 - 230 °C in steps of
20°. The thicker your hair, the higher the
selected temperature may be. Chemically
treated hair should be straightened at a
lower temperature adjustment. Try and see
which adjustment gives you the best results.
The selected temperature will be indicated
correspondingly in the display.
9. Heat the appliance up for a couple of
minutes in order to achieve the best styling
result. The flashing toolbar indicates that
the appliance is heating up. As soon as the
desired temperature is achieved, the toolbar
stops flashing.
10. Open the appliance and place a small
section of hair between the straightening
plates close to the root.
11. Shut the appliance.

cleanIng anD care

1. Unplug the appliance from the wall socket.
2. Let the appliance cool off completely placing it
on a heat resistant surface.
3. Never immerse the appliance or the lead
cable in water or other liquids to clean them.
4. Clean the appliance with a damp cloth.
5. Do not use any scrubbing sponges, abrasive
agents, steel wool, metal objects, disinfect-
ants or hot cleaning agents, since they can
damage the appliance.
12
12. Now work your way down slowly and evenly
to the ends of your hair. Maintain the
appliance firmly closed during this process.
Never work the same part for more than two
seconds to avoid damaging your hair. For
an even and straight look, work your way
straight down keeping the appliance close
to your head. Working your way through
slightly lifting the appliance will give your
hair more volume.
13. Please remember that the straightener
plates are very hot after use.
14. Switch the appliance off pushing the button
EIN/AUS [ON/OFF] for two seconds and
disconnect the plug from the wall socket.
The appliance is equipped with a security
shutoff device that automatically switches
the appliance off after 60 minutes of
inactivity. The clock in the display indicates
when the automatic shutoff will be executed:
every 15 minutes the needle moves on and
the appliance will be switched off after the
last 15 minutes. If you want to go on using
the appliance, push the button EIN/AUS
[ON/OFF] for two seconds. The appliance
will be switched on again.
15. TIP: You can also curl your hair with the
straightener! Place the strand between the
plates as usual and straighten your hair.
Shortly before the ends of your hair, turn
the appliance to the inside or the outside
(according to the desired look) to give your
hair a gentle movement to inside or the
outside.
attention: the appliance becomes very hot
during operation. avoid direct skin contact.
danger of burns!
6. Protect the appliance from dust and clean
the air inlets with a soft brush, if necessary.
7. Clean the straightener plates with a damp
cloth, if necessary. Let the attachments
dry completely before using them again or
storing them. Persistent dirt can be easily
removed with a soft brush.