Apricorn Aegis Fortress L3 Guía De Referencia Rápida

Aegis Fortress L3
NOTE: if you are using the Aegis Configurator (sold separately) to set up
your Aegis Fortress L3, First ensure that the device to be configured has the
CONFIGURABLE
"configurable" logo on the belly label. Also, DO NOT perform the following Manual
Admin and USER PIN SETUP steps below; The Aegis Configurator will only recognize
devices in their factory "out of box" state or devices that have been completely reset.
First Time Use
Before the Fortress L3 can be used, the Admin PIN MUST be set. The LEDs will glow Solid
BLUE GREEN
and Solid
To Set-up the Admin PIN:
1. Press + 9 simultaneously. The LEDs will be Constant
2. Enter the new Admin PIN and press the
off, the GREEN
Blinking GREEN.
3. Re-enter that Admin PIN and press the
glow solidly for three seconds.
4. The BLUE LED will glow solidly indicating the drive is in Admin mode and will remain
that way for 30 seconds or until the
drive to its standby (locked) state.
5. The Admin PIN is now set and will allow access to the drive or the Admin features.
6. To access the drive's data using the Admin PIN, press the
new Admin PIN and press .
Note:
PINs must be a minimum length of 7 maximum 16 digits.
Cannot contain all consecutive numbers (2345678 or 9876543)
Cannot contain all same number (1111111)
The SHIFT key can be used for additional combinations.
SHIFT + 1 are a separate value than just 1.
1
2
3
to indicate the Fortress is waiting for an Admin PIN to be set.
LED will blink three times, and then will return to Solid
Quick Start Guide
1
LED Indicator lights
2
3
When you first plug in the Aegis Fortress L3,
the unit will do a self-test to verify all security
components are working properly. The LEDs will
go through 3 test stages: RED, GREEN, and
BLUE. This will be followed by three
blinks indicating all components are functioning
properly. A test failure will leave the unit in an
inoperable state indicated by a blinking
BLUE
key. If accepted, the
key again. If accepted, the
key is pressed, either of which will return the
UNLOCK button
LOCK button
GREEN
RED
/ Blinking GREEN.
BLUE LED will turn
BLUE and
GREEN
LED will
button, then enter the
LED.