DeWalt DWE46170 Manual De Instrucciones página 7

Mounting and Removing Surface Grinding
Shroud (Fig. 2A–D)
NOTE: The shroud and adaptor (G) have a
tight fit onto the grinder. Take extra care when
mounting the shroud.
1. Follow the mounting and removing guard
instructions in the power tool manual to
remove the existing guard from grinder.
2. If present, remove the stop screw (I)
from your D WALT Grinder with a T40
E
star wrench. If a star wrench is
unavailiable, use a flat
screwdriver or a pair locking pliers to
remove the screw.
3. With the beveled edge facing
upward from the shroud collar, insert
the gear case adaptor (G) partially
into the collar as seen in figure 2B.
4. Aligning the adaptor and shroud with the gear casing, push the
both down onto the gear case with your thumbs. You can also
use a large flathead screwdriver to be sure the adaptor is seated
correctly. Both the shroud and the adaptor should slide down onto
the gear case at the same time.
FIG. 2C
FIG. 2A
I
G
FIG. 2B
head
5. Position shroud to desired orientation,
and tighten hose clamp screw (A)
securely.
6. To remove the shroud, repeat these steps
in reverse.
NOTICE: If surface grinding shroud cannot
be tightened by the hose clamp screw, do
not use the tool and take the tool and surface
grinding shroud to a service center to repair
or replace the surface grinding shroud.
Mounting Dry Diamond
Surface Cup Wheels
(Fig. 3)
Follow the mounting and using cutting
wheels instructions in the tool manual
and mount the grinding wheel. DO NOT
use Type 1 cutting wheels or bonded
abrasive wheels.
Dry diamond surface cup (J) wheels are
recommended for use with this shroud.
The inner soft mount washer (K) should
be installed behind the wheel, allowing
free tool removal and proper fit and
alignment to shroud.
Hose Connection (Fig. 4–6)
WARNING: Use only power tools recommended by D
this attachment.
For more information about D
E
attachment, please contact your local dealer, call 1-800-4-D
(1-800-433-9258) or visit our website www.dewalt.com.
5
FIG. 2D
FIG. 3
J
K
WALT with
E
WALT power tools compatible with this
WALT
E
A