Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ADVANCED PRODUCT FEATURES
Jam Blocker
TM
Blocks jams before
they start
JAM BLOCKER
Blocks jams before they start
1
2
If Remove Paper icon ( )
Reduce paper quantity
is illuminated, there is too
to an acceptable
much paper for the shredder
amount and refeed
to power through
into paper entry
SAFESENSE
®
Stops shredding immediately when hands touch the
paper opening.
SET-UP AND TESTING
1
2
Set to Auto On (
)
Touch test area and
look for the SafeSense
indicator to illuminate
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished sheet
capacity, intrusive noise when shredding and could ultimately
stop running. To avoid these problems, we recommend you
oil your shredder each time you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Remove Paper: When illuminated, set to reverse (
SafeSense
®
Indicator: If hands are too close to the paper entry, the SafeSense
is active for 3 seconds, the shredder will automatically turn off and the user must set the switch to OFF ( ), then Auto On (
Patented SafeSense
Stops shredding immediately when
hands touch the paper opening
TM
1
Shredder pauses for
3 seconds
TECHNOLOGY
3
SafeSense
is active and
If hand is held on SafeSense
®
working properly
area more than 3 seconds
®
shredder will shut off
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to OFF ( )
) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
Technology
®
If Remove Paper icon illuminates during the shredding process
(due to paper misfeed or wrinkle) follow the procedures below.
2
Set to Reverse (
and remove paper
standby mode and sleep mode.
4
WHEN IN SLEEP MODE
1
®
In sleep mode
2
*Apply oil across entry
®
indicator will illuminate and the shredder will stop shredding. If SafeSense
Energy Saving System
Optimal energy efficiency 100% of
the time – in use and out of use.
3
Set to Auto On (
) and
)
refeed into paper entry
ENERGY SAVING SYSTEM
Optimal energy efficiency 100% of
the time – in use and out of use.
2
or
To get out of sleep mode
set to OFF ( ), then
Auto On (
)
3
Set to Reverse (
)
for 2-3 seconds
®
) to resume shredding.
3
Insert paper
3
Publicidad
Tabla de contenido
