Installing the Batteries
ATTENTION: Batteries should only be installed by an adult.
The unit comes with batteries already installed. These batteries
are meant for in-store demonstration use only, and should
be replaced with fresh batteries. To replace the batteries at
home, follow these instructions for each blaster:
1
Use a Philips screwdriver
to open the battery
compartment door.
Install 3 "AA"
size
2
batteries
into
the
compartment, making
sure that the + and -
polarities
match
diagram printed inside.
3
Close
the
battery
compartment door and
tighten the battery door
screw. Don't over tighten.
For the Best Possible Performance
• Only use the recommended/supplied batteries or
equivalent.
• Use alkaline batteries for longer life.
• Do not mix old and new batteries, and do not mix
alkaline, carbon-zinc or rechargeable nickel-cadmium
batteries.
• Insert batteries with proper polarity (+/–) as indicated.
• Remove exhausted batteries from product.
• Recharge
rechargeable
supervision.
• Do not attempt to recharge non-rechargeable batteries.
• Do not open batteries or heat them beyond normal
ambient temperatures.
• To prevent battery leakage or damage remove batteries
from a product if it will not be used for a month or longer.
• Use extreme caution handling leaking batteries (avoid
direct contact with eyes and skin). If battery leakage
comes in contact with eyes, IMMEDIATELY flush the eye
with lukewarm and gently flowing water for at least 30
minutes. If skin contact occurs, wash skin with clear
water for at least 15 minutes. Seek medical attention if
any symptoms occur.
• Store in cool, dry, ventilated area away from hazardous
or combustible material.
• Do not dispose of batteries in the household trash or fire.
• Follow applicable laws and local regulations for the
disposal and transportation of batteries.
• Rechargeable batteries are to be removed from the toy
before being charged.
• The supply terminals are not to be short-circuited.
Battery Installation
the
batteries
under
Troubleshooting
The blasters support a range of approximately 70 feet
outdoors and 120 feet indoors. For best performance,
aim at your opponent's blaster. Direct sunlight may
affect the range and performance of the blasters. Please
keep in mind that this product does not transmit well
through obstacles such as trees, buildings, and metal
structures. If the signal range of the blasters decreases
notably, you may have to change your location. If the
signal range is still shorter than expected, replace the
batteries.
ON/OFF/DEMO Mode
This unit ships in Demo Mode for in-store
demonstration purposes. When ready
to play, slide the ON/OFF/DEMO Switch
to ON Mode.
Questions or Comments
For questions or comments regarding this or other
eKids products, please call our toll-free number:
1-888-TOP-TOYS.
Please also visit our website: www.ekids.com
adult
Maintenance
It is important to keep the unit as dry and clean as possible.
Clean the unit with a soft cloth moistened only with mild soap
and water. Stronger cleaning agents, such as thinner or similar
materials are not
of the case.
© 2020 eKids, LLC. All Rights Reserved.
Printed in China
2
recommended, as they may damage the surface
1299 Main Street Rahway NJ 07065
IC/RW174.11-021320-A(EN)
EN
ON/OFF/DEMO
Switch