Numark iCDMIX 3 Guia De Inicio Rapido página 5

13. LOOP OUT – Sets the end point of a loop (a "Loop Out" point) and starts playing the loop. While playing a loop, press
LOOP OUT to release it from the loop and continue normal playback.
14. RELOOP – Plays the track immediately from the beginning of a loop (and reactivates the loop).
15. PITCH – Adjusts the range of the PITCH FADER (±4%, 8%, and 16%) or deactivates it. The current range will be
indicated on the LCD and by different LED colors.
16. PITCH FADER – The pitch can be changed by pressing the PITCH button so a PITCH LED is lit, then moving the sliding
fader. The pitch will not be changed if the PITCH LED is off.
17. PITCH BEND -/+ – You can use these two pitch bend buttons to temporarily adjust the pitch and tempo of the music up
to -/+ 4% from the current pitch setting.
18. LCD – Indicates all the functions, as they are occurring, with the CD.
19. INPUT SELECTOR – Selects the input source to be routed to the corresponding channel. Input jacks are located on the
rear panel.
20. CHANNEL GAIN – Adjusts the channel's pre-fader and pre-EQ gain level.
21. CHANNEL TREBLE – Adjusts the high (treble) frequencies of the corresponding channel.
22. CHANNEL MID – Adjusts the mid-range frequencies of the corresponding channel.
23. CHANNEL BASS – Adjusts the low (bass) frequencies of the corresponding channel.
24. CHANNEL FADER – Adjusts the audio level on the corresponding channel.
25. CHANNEL CUE – Sends pre-fader audio to the Cue Channel for headphone monitoring.
26. CUE MIX – Turn to mix between Cue and Program in the Headphone channel. When all the way to the left, only
channels routed to CUE will be heard. When all the way right, only the Program mix will be heard.
27. CUE GAIN – Adjusts the audio level of the Cue channel.
28. HEADPHONES – Connect your 1/4" or 1/8" headphones to this output for cueing and mix monitoring.
29. MIC ON / OFF – Mutes and unmutes the microphone signal. When muted,
the microphone signal will not be routed to the Master mix.
30. CROSSFADER – Blends audio playing between Channels 1 and 2.
Sliding this to the left plays Channel 1 and sliding to the right plays
Channel 2.
31. FADER START – When fader start is "ON," moving the CROSSFADER to a side will cause that deck to start playing
automatically (if it is paused). When fader start is "OFF," you will need to start playback on each deck manually.
32. STEREO LEVEL INDICATOR – Displays the audio level of the Program mix.
33. MASTER VOLUME – Adjusts the output volume of the Program mix.
34. ZONE VOLUME – Controls the audio level of the Zone output.
35. MONO / STEREO – Adjusts the Program mix for stereo or mono operation.
36. DOCK – Connect your iPod here. Gently rock the iPod back and forth over the connector when attaching or removing it.
37. DOCK ADJUSTER – Turn this knob accordingly so your docked iPod rests against the support.
38. iPod CONTROLS & JOG WHEEL – Functions as the controls for your iPod's menus and Touchwheel while it is plugged
into the mixer.
Note: When connecting microphones,
make sure the mic channel's gain knob
is at the lowest setting (or turn the mic
channel off) before connecting it.
5