Vision TC-HDMIW30C Manual Del Propietário página 7

FREQUENCY SPECTRUM
This product uses 5GHz WIFI channels so it can be affected by outside interference in the same
way as any wifi device.
IR PASSBACK
If using a source device which has a remote control, this product allows the remote to be
pointed at the display in the remote location. The IR signal is relayed from the Rx to the Tx to
the source device.
To make this happen the IR blaster and receiver cables mush be used.
• The diode on the blaster must be as close as possible to the source IR receiver.
The diode on the receiver must be in line-of-sight of the remote control.
•
NOT WORKING?
1. Check USB cable powering Tx. Cheap USB cables will not provide enough power.
2. The computer is set to duplicate or extend the desktop (Control Panel\Appearance and
Personalisation\Display\Screen Resolution)
3. Try other cables between the source and Tx
4. EDID handshakes and HDCP key authentication can create HDMI issues. Try rebooting all
equipment to reset.
5. Check the wifi spectrum with a tool such as https://inssider.en.softonic.com/
TC-HDMIW30C_manual_en.doc
7