Kalorik CHM 41044 Manual De Instrucciones página 6

Fax +32 2 359 95 50
ASSEMBLY
Make sure all switches are in OFF position and that the appliance is
unplugged before assembling. Never attempt to place the auger or
the tower on the base while the motor is running.
First, assemble the 4 parts of tower together (3 disks + 1 central tube).
Then, to assemble the appliance, put the auger on the axle in the
center of the bowl, and pass the tower over the auger, making sure
that the three openings on the bottom of the tower fit in the three
pins in the center of the bowl.
To work properly, the surface must be level. If it is not completely
level, you can adjust the position of the appliance by turning the
height-adjusting feet (6) in the adequate direction.
HOW TO USE
Once the appliance is correctly assembled, plug it into a wall
•
socket.
To start, turn the switch (1) clockwise to activate the heater ("in
•
"HEAT" position). The pilot light goes on, indicating that the
appliance is heating.
Let the unit warm up for at least 3 to 5 minutes before adding the
•
melted chocolate.
In the meantime, prepare the chocolate as follows:
•
Combine 1.5lbs / 25 oz. of chocolate chips with 1 cup of cooking oil
(for example canola oil) in a microwave safe bowl. Place the bowl in
the microwave and heat for 2 minutes. It is advised not to heat at full
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity. Print only what is inside the frame.
6
Assembly page 6/36
CHM 41044 - 120501