Toptech TT-P-411 Manual De Instrucciones página 2

2 Installation
Warning
Thermostat Location
Install the thermostat approximately 4-5 feet (1.2 - 1.5m) above the floor in
an area that has a good amount of air circulation and maintains an aver-
age room temperature.
Avoid installation in locations where the thermostat can be affected by
drafts, dead air spots, hot or cold air ducts, sunlight, appliances, concealed
pipes, chimneys and outside walls.
Install your new TopTech thermostat in 5 basic steps:
1 Install the Sub-Base
2 Provide Power
3 Connect Your Wires
4 Set Installer Switches
5 Attach Thermostat to Sub-Base
Install the Sub-Base:
1
• Remove the sub-base from the body of the thermostat.
• Mount the sub-base as shown below:
Drill 3/16" pilot holes in
your desired location.
Use supplied anchors for
drywall or plaster.
2
Provide Power
• For 24 Volt AC power, you must connect the common side of the trans-
former to the C terminal on the thermostat sub-base.
• For primary or back-up power, insert the 2 supplied "AA" type alkaline
batteries into the battery compartment located on the front of the ther-
mostat near the bottom. Make sure to position the Positive (+) and
Negative (-) sides of the batteries correctly with the +/- symbols in the
battery compartment.
Disconnect power before beginning installation.
2