Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Using 8 of the included 8-32 screws and washers, mount the blower in
place and tighten all screws. Confirm that the blower is securely seated
in place and there are no air gaps around the blower gasket.
3.
Plug the 3 wire quick connect cord from the blower into the receptacle on
the range hood canopy. Plug the 4 wire quick connect cord from the blower
into the one end of the wiring harness then connect the other end of the
wiring harness to the receptacle in the range hood canopy. These cords
will only fit into the receptacles one way (Figure 2).
Wire
Harness
Figure 2
SECTION 3
Installation into 10" High Canopy
1.
Remove the rear bottom plate of the hood canopy. It is secured in place
with a screw and washer on either side (Figure 3).
Bottom Plate
Figure 3
2.
Lift blower up into the hood canopy and slide the keyhole slots in the blower
mounting flange over the two studs of the hood. Slide the blower into place
and tighten the hex nuts on the mounting stud while lining up the 8 holes
in the blower mounting flange to the 8 screw studs of the hood (Figure 1).
3.
Using 8 of the included 8-32 screws and washers, mount the blower in
place and tighten all screws. Confirm that the blower is securely seated
in place and there are no air gaps around the blower gasket.
#
Qty. Description
1
1
Blower Assembly
2
1
Blower Gasket
3
8
Grommet
4
8
Washer
5
8
8-32 Screw
6
1
Capacitor
7
1
Screw
8
1
Wire Harness
9
1
Fuse
111597002 New 3-07
Receptacles
Blower
Screw
Washer
REPLACEMENT PARTS DIAGRAM
Replacement Part #
5S1136110
5S1136112
5S1136101
5S1136102
5S1136103
5S1136116
5S1136117
5S1136118
5S1136106
www.airkinglimited.com
4.
Plug the 3 wire quick connect cord from the blower into the receptacle on
the range hood canopy. Plug the 4 wire quick connect cord from the blower
into the one end of the wiring harness then connect the other end of the
wiring harness to the receptacle in the range hood canopy. These cords
will only fit into the receptacles one way (Figure 2).
5.
Reinstall the rear bottom plate by fitting the back edge of the plate into the
channel located on the back of the hood and reinstalling the two screws
and washers removed in Step 1 (Figure 4).
Bottom Plate
Figure 4
SECTION 4
Finishing the Installation
1.
Install the included fuse into the electrical panel by turning the fuse cap
counter clockwise and pulling out. Insert the included 1/4" x 1-1/4" time
delay fuse in the holder and reinstall into the panel (Figure 5).
Cap
Figure 5
NOTE: If you need to replace the fuse, replace with a 1/4" x 1-1/4" Bussman
MDA-3 or equivalent 3 amp, 250V ceramic, time delay fuse only.
2.
Refer to the hood instruction manual to complete the installation, for
maintenance, and before restoring power.
3.
The blower is covered under the range hood's warranty.
9
5
8
Screw
Washer
Channel
Fuse
3
4
2
1
6
7
2 of 8
Publicidad
