Famastil P1121.500 Manual De Instrucciones página 30

If you find that the nylon line is
02
too short follow the instruction as in
preparing the trimmer for use' section
2 (see FIG10). Let the trimmer run for
a few seconds without touching the
working area, and allow the trimmer to
cut the line. Use the trimmer at an angle
of approximately 20 degrees to the
working area. (see FIG 14). Swing the
trimmer from side to side, (see FIG 15).
Use the edge of the guard as a guide
03
when using near fences walls etc, and
move in a backwards direction, (see FIG
16 and FIG 17).
Do not overload your trimmer, take
04
small "bites" this will keep machine
operating at high speed and will greatly
improve cutting efficiency, (see FIG 18).
01 To replace the nylon line, first remove the spool cover from the spool holder by
pushing down centre of the spool and at the same time pressing the two spool cover
opening buttons firmly, now remove the empty spool and replace with a new pre-
wound spool (see FIG19).
02
Insert the line through the "brass"
holes on the spool holder, pull line out.
Push spool inwards against the spring
clip and then push spool cover firmly
downwards until it locks into position
and at the same time pull lines and be
sure that they are released from spool
rail notches. If not, the bumping-feed
will not operate. Follow the instruction on
cutting the line in "Preparing the trimmer
for use" section 1 before use. (see FIG9)
30
TO REPLACE THE CUTTING LINE
Always unplug the trimmer
before carrying out any maintenance.
FIG 14
FIG 16
FIG 15
FIG 17
FIG 18
FIG 19