Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Maintenance
Do a general inspection
Examine the oil level
Clean the product
Examine the cutting equipment
Examine the cutting cover*
Examine the engine brake handle*
Examine and adjust the drive (clutch wire)
Examine the muffler*
Examine the spark plug
Change the oil (the first time after 5 h use, then after each 50 h use)
Change the air filter
Examine the fuel system
To do a general inspection
•
Make sure that the nuts and screws on the product
are tightened.
To clean the product externally
•
Use a brush to remove leaves, grass and dirt.
•
Make sure that the air intake on the top of the engine
is not blocked.
•
Do not use a high pressure washer to clean the
product.
•
If you use water to clean the product, do not flush
water directly on the engine.
To clean the inner surface of the cutting
cover
1. Empty the fuel tank.
2. Put the product on its side with the muffler down.
350 - 004 - 17.10.2017
Maintenance
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 8 .
3. Hose down the inner surface of the cutting cover
with water.
To examine the cutting equipment
1. Examine the cutting equipment for damage or
cracks. Always replace a damaged cutting
equipment.
Daily
Weekly
X
X
X
X
X
X
X
X
X
CAUTION: If the product is put with the
air filter down, the engine can become
damaged.
WARNING: To prevent accidental start
remove the ignition cable from the spark
plug.
WARNING: Use protective gloves when you
do maintenance on the cutting equipment.
The blade is very sharp and cuts can easily
occur.
Monthly
X
X
X
11