Safety Instructions - Danby DKC5411BSL Manual De Instrucciones

Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
FOR YOUR SAFETY: Pertaining to the risk of Fire, Electric Shock or Injury to Persons.
GROUNDING
INSTRUCTIONS
WARNING CO CAN BE
2
DANGEROUS!
CO2 Cylinders when charged contain
high pressure compressed gas which can
be hazardous if not handled properly.
Read and understand the following
procedures for CO2 cylinders before
installation;
WARNING
If it becomes difficult to breathe and/or
your head starts to ache, abnormal con-
centrations of carbondioxide (CO2) may
be present in the area....
CLOSE THE MAIN VALVE ON THE
CO2 CYLINDER, VENTILATE AND
LEAVE THE ROOM IMMEDIATELY!
• This appliance must be grounded. In the event of a malfunction or
breakdown, grounding will reduce the risk of electric shock by providing
a path of least resistance for electric current.
• This appliance is equipped with a power cord having an equipment
grounding conductor and grounding plug. The plug must be plugged into
an appropriate wall outlet that is installed and grounded in accordance
with all existing local codes and ordinances.
• Consult a qualified electrician or service person if the grounding
instructions are not clearly understood, or if doubt exist as to whether
your electrical wall outlets are properly grounded.
1. Always check the D.O.T.
(Department of Transport) as
well as the T.C. (Transport
Canada) testdate located on the
neckof the cylinder before
installation. If the date is older
than five (5) years,do not use,
return the gas cylinder to a gas
supplier for re-certification
(service charges may be
applicable).
2. Always connect a CO2 gas
cylinder to a regulator.Failure to
do so could result in an
explosion which can possibly
result in death or injury when the
cylinder valve is opened.
3. Never connect a CO2 gas
cylinder directly to beer keg.
4. Always secure a CO2 gas
cylinder in an "upright" position.
5. Always keep a CO2 gas cylinder
away from heat.
6. Never drop or throw a CO2 gas
cylinder.
7. Never connect a CO2 cylinder
unless there are two (2) safety
mechanism's in the pressure
system;
(a) One at or on the CO2 regulator.
(b) One at or on the product
container coupler in the
pressure gas line.
3
NOTE: The regulator andkeg
coupler supplied with this unit are
inclusive of such safety
mechanisms.
8. CO2 gas cylinders should be
stored in the coolest part of the
establishment (preferably) at
70ºF (21ºC) and must always be
securely fastened in an "upright"
position.
9. Always ventilate area after any
leakage of CO2.