Zagg Power Amp 6 Manual De Instrucciones página 2

INTRODUCTION
With your new Power Amp 6, you'll never have to miss out again because of a
dead battery. Just read and follow these instructions, keep your Power Amp 6 by
your side on all your adventures, and never let your battery die again.
USB Port
LED Flashlight
Micro USB charging port
CHARGING YOUR DEVICES
Your Power Amp 6 carries enough power to charge your phone up to two times*.
In addition, it allows for pass-through charging that lets you power your devices
even while it's plugged in. To keep your phone from dying:
1. Connect the USB end of your charging cable to the outlet on the
Power Amp 6.
2. Connect the other end of your charging cable to the device you want to
charge — the Power Amp 6 will automatically begin charging it.
3. Continue on your activity until your device is charged to your liking and
then disconnect the charging cable.
4. Recharge your Power Amp 6.
*Up to two charges based on a 1800mAh battery.
CHARGING YOUR POWER AMP 6
Your Power Amp 6 comes charged and ready to go; but here's how to recharge it
when you need to:
1. Connect the included micro USB charging cable to the micro USB
port on your Power Amp 6.
2. Connect the USB end of the included cable to your preferred 5V USB
outlet. Note: Do not leave your Power Amp 6 plugged into a wall charger
for extended periods of time. Doing so will diminish its long-term
performance.
3. The LED under the USB outlet will light and flash according to its
current battery level. This indicates your Power Amp 6 is charging.
4. Wait for the battery indicator lights to turn off, indicating your Power
Amp 6 is fully charged.
5. Disconnect the charging cable and enjoy 6000mAh of simple,
portable power.