Hotronic FootWarmer CUSTOM Power Plus S4 Instrucciones Operadoras página 13

CAUTION:
1. DO NOT CUT Power Cord.
2. DO NOT CUT Heating Element located inside Heating Element
door.
3. Place red fabric, heated side of Insole up when installing in
footwear.
If using Hotronic's ONE SIZE FITS ALL INSOLES in footwear with
removable insoles:
1. Align tips of both insoles.
2. Trace removable insole on backside of Hotronic Insole around
sides and heel.
3. Trim Hotronic Insole to size of removable insole.
4. Hotronic Insole may be placed on top of removable insole or in
place of.
If using Hotronic's ONE SIZE FITS ALL INSOLES in footwear without
removable insoles:
1. Trace outline of foot on backside of Insole with TOES aligned
over top of Heating Element.
2. Cut Insole along sides and heel. (Fig. 28)
3. Select slightly larger sizing line at first.
4. Further trim Insole where necessary.
If using Hotronic's SEMI CUSTOM INSOLES:
1. First select best size SEMI CUSTOM Insole and install Heating
Element.
2. Place Insole inside footwear.
3. If Insole fits well inside footwear, no further trimming is
necessary.
4. If Insole needs trimming, use trim-to-size lines on bottom side of
Insole toe area. (Fig. 27)
5. Trim Insole as needed.
INSTALLING HEATING ELEMENTS ON CUSTOM INSOLES
1. With foot on custom insole, position Heating Element under toes
placing Power Cord toward heel. (Fig. 14-16)
2. Remove foot, carefully lift Heating Element slightly, and mark
position on insole where Power Cord descends from Element.
3. Use razor knife or grinding device to make slit or narrow opening at
marked position. Hard insole material may require wider opening
for Plug. Use heat gun to soften hard material for narrowest opening.
(Fig. 17)
4. Run Power Cord through slit or opening until Element lies flat and
in correct position. (Fig. 18)
5. Remove adhesive cover layer on bottom of Element and adhere
Element in correct position. If Element is without self-adhesive layer,
use spray or brush-on adhesive between insole and Element.
6. Apply self-adhesive fabric cover over top of insole. Trim excess with
scissors AFTER applying. If needed, use additional adhesive between
insole and fabric. (Fig. 19-20)
7. Apply self-adhesive fabric strip over Power Cord on bottom of insole
to hold in place. (Fig. 21)
8. If foot is sensitive to Power Cord, create shallow channel where
needed under insole using razor knife or grinding device. Reapply
fabric strip.
INSTALLING INSOLES IN GENERAL FOOTWEAR
1. Place insole in footwear with Power Cord flat underneath.
2. Run Power Cord up back or side of leg.
3. Securely fasten Battery Pack as per instructions.
4. Plug Power Cord into Battery Pack.
(Fig. 14-21)
(Fig. 14-28)
- 12 -