Attaching Discharge Elbow; Removing Knockout Plug - Westinghouse Platinum Serie Manual Del Usuario

Installation (continued)
If at any time the bottom supporting ring becomes
disengaged from the body of the waste disposer, then:
1 . Align the slot in the bottom supporting ring with tab on
the waste disposer body .
2 . Lower the bottom supporting ring and make the slot
fit in the tab.
3 . Turn the bottom supporting ring counter clockwise to
secure it in place .

ATTACHING DISCHARGE ELBOW

- Make sure the elbow gasket is attached to the
discharge elbow correctly (see Fig . 9a) .
- Connect the discharge elbow to the disposer
(see Fig . 9) .

REMOVING KNOCKOUT PLUG

If you are using a dishwasher, complete the following procedure . If no dishwasher is to be
connected, skip this section .
- Using a blunt instrument (steel punch or wooden dowel), knock out the entire plug
(see Fig . 10) . Do not use a screwdriver or sharp instrument . When the knockout
plug falls into the disposer, you may remove it, or grind it up when the disposer is
being used . This will not damage the disposer in any way, but may take some time
to grind .
Slot
Tab
Elbow Gasket
Fig. 9a
7
Please contact customer.service@conglomkb.com or 1-877-333-0098 for further assistance .
Groove
Discharge Elbow
Knockout
Plug
Wood or
Metal Dowel
Fig. 9
Fig. 10
CONGLOMKB .COM