Connections To Be Made - Axxess BX-MB2 Instrucciones De Instalación

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
The following (3) wires are only for multimedia/navigation radios that require
these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• Tape off and disregard the following (10) wires, they will not be used in this
application: Blue/White, Brown, Gray, Gray/Black, White, White/Black, Green,
Green/Black, Purple, Purple/Black.
BX-MB2

Connections to be made

• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
2
From the LD-BX-MB1 or LD-BX-MB2 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the power antenna on wire.
Continue to 3.5mm jack steering wheel control retention