Guided Tour - Ap1 Receiver - Samson AirLine AF1 Manual Del Propietário

Samson AirLine
2
ON
POWER
BATT. LOW
1
4
∞
LEVEL
AP1
U HF R E C EI V E R
6
OPEN

Guided Tour - AP1 Receiver

3
TX
PEAK
5
1: Power switch - Move this switch in the direction of the arrow to turn
power to the AP1 on; move it away from the arrow to turn power off. (A
jack must be inserted into the input connector for the receiver to power up.)
2: Power On / Battery Low LED - This LED lights green whenever the
AP1 is powered on and it lights red whenever the battery in the AP1 is
running low. In order to avoid compromising audio fidelity (or having
the AP1 stop working completely), you should always replace the bat-
tery with a fresh one immediately whenever this LED lights red.
3: TX / Peak LED - This LED lights green whenever the AP1 is receiving
RF signal from a transmitter and it lights red when output signal from
the AP1 is at the onset of clipping (that is, when it is on the verge of
being distorted). If you see this light during operation, lower the vol-
ume level of your instrument or switch on the transmitter's 15 dB pad.
For more information, see the section entitled "Setting Up and Using
Your AirLine System" on page 15 in this manual.
4: Level control - This knob sets the level of the audio signal being
output through the AP1 output jack (see #9 on page 9). When using an
electric guitar or bass with an active or high-level pickup, set the knob
in the marked area. For more information, see the section entitled
"Setting Up and Using Your AirLine System" on page 15 in this manual.
4