Mark MBAR 612 BAT WI Manual De Uso página 13

6) Then press the【UP/DOWN】button to select 【RED】...【SHUT】，【TIME】，【WAIT 】，【USE】
7) Press the【UP/DOWN】button to set up the parameter which are needed.
8) Press the【ENTER】button t o escape and save.
Illustrations ：When 【 USE】 is set to be 【NO】 ，or the parameter of 【 TIME】 is 0, it will not run this scene.When
【WAIT 】is set to be FADE time, the running process isas the following chart showing.
6.14 CHECK THE LIGHTING INFOR MATION
1) Press the【ENTER】button in 【INFO】menu, then enter to the checking the lighting information.
【 】
2) SOFT button is for software version information.
3) 【POW】button is for the current information of power reduction. It is 100% output in normal conditions, but
80% or 50% output in over temperature protection situation.
【 】
4) BAT Remaining battery power, from 0-10
6.15 LIGHTING SETTING PARAMETER RESET
1) Press the 【ENTER】button in 【ST L】menu, then enter to the lighting setting parameter reset.
2) Press the 【UP/DOWN】button to select 【YES】.
3) Press the 【ENTER】button to escape and save.
Illustrations ： "ADDR" "CTST" and "PROG" are not reset, the others reset to the underlined value of the word.
6.16 【PROG】SELF-PROGRAMMING PARAMETER RESET
1) Press the【ENTER】button in 【PR L】menu, then enter to the 【PROG 】self-programming parameter reset.
2) Press the【UP/DOWN】button to select 【YES】.
3) Press the【ENTER】button to escape and save.
6.17 LIGHTING PARAMETER DOWNLOADING EACH OTHER VIA DMX
CABLE
1) Press the 【ENTER】button in 【SEND】menu, then enter to sending parameter to other lightings.
MBAR 612 BAT WI - 12 -
User Manual/Manual de Uso
EN