Palram Olympia 3x3.05 Manual De Instrucciones página 9

Notes During Assembly
Use
a
soft platform below the parts to avoid scratches and damages.
Please note you install the panels
with
the
UV
protected
side
out
(marked
with
"THIS
SIDE
OUT")
and peel the film strip covering the
panels.
Product dimensions
can be
adjusted to your specific
needs:
1.The wall-mounting profile (top-back)
can be
adjusted from 260
to
305 cm (102.4"
to
120") above ground.
The
adjusting
is
done when measuring and drilling (Step
5).
Please
note the installation recommendations' height suggested
in
Diagram
A.
Please
note that the product appearance may slightly change
as
a
result, however snow load weight does not change.
2. Poles
distance from the wall
can be
adjusted from 226
to
286 cm (89"
to
112.6")
as
suggested
in
Diagram
B1.
Poles
distance from the side edges can be adjusted from
5
to
54 cm (2"
to
21.6")
as
suggested
in
Diagram
B2.
The
adjusting
is
done after assembly and before anchoring (Step 16) by sliding poles and profile 8619+8620 at the roof
profiles' channels.
3. Wall
mounting and distance from the wall determine the roof angle and the total depth of the product (distance of
gutter from the
wall). Higher wall
mounting
and shorter distance between wall and poles increase the roof angle and
shorten the total depth
as
suggested
in
Diagram
C.
Ste'
Step 5: It
is
important to
plan the installation
area,
mark
as
per the instructions and level the surface prior to the
assembly. Make sure you
use
suitable screws and anchors.
Step 7:
Apply silicone
sealants above beam
7288,
in
order to prevent water from seeping
in.
Step
9: Make sure
that the angle between the back wall profile and the panel supporting profiles
is
90 degrees.
Step 11:
Please
note you install the panels with the
UV
protected
side
out
(marked
with
"THIS
SIDE
OUT")
and peel the film strip covering the
panels.
Step 14a: Apply silicone
sealants on
the inner part of 7997, and connect to the profile
as
depicted
in
drawing
14a.
Step 14c:
Do
not tighten
screw
4043
yet, in
order to allow the final adjustments done
in step 16b.
Step 16a+16c:
Please
adjust the poles (inside out and sideways) by sliding them to their final position prior to
anchoring.
Make sure
that
the poles distance from the Patio cover side
edge does not exceed 54 cm/21.3':
Step 16b: Adjust the
gutter
head's angle according to your needs and
tighten
screws 4043.
Step 18: Anchoring this product to the ground
is
essential to its
stability
and
rigidity.
It
is
required to complete
this stage
in
order for your warranty to
be
valid.
*Tighten
all screws
when completing
assembly.
The
wall anchoring kit supplied with this product
is
suitable for concrete or solid brick
walls only. Other wall types need an accordant wall fixation kit.
II
260-305cm
102.4"-120"
13°
LTA
-13
17°