Publicidad
Idiomas disponibles
Idiomas disponibles
requires the use of special tools, if the supply cable is
damaged, contact an authorized Service Centre.
- Do not allow the supply cable to come into contact with the
ironing plate.
- If the safety cut-out intervenes, the iron will no longer
function. To restore normal operation. Contac a qualified
electrician.
- Never direct the steam jet in the direction of persons, as
this may be extremely dangerous.
- Do not use the iron on very wet fabrics.
- Do not place the iron to the person on the stand when the
plate is hot.
- Do not overfill the water tank and do not add stain-
removers of similar products to water.
- Remove the plug from the mains socket when the appliance
is not in use. Do not leave the appliance switched on
unnecessarily.
- EEC Directive 87/308(D.M. 13/04/89)。Keep this booklet in
safe place for future reference. This appliance complies with
EEC Directive 87/308(D.M. 13/04/89) regarding the
suppression of radio disturbance
PREPARATION FOR USE
The appliance uses ordinary tap water.
If the water is very hard (hardness higher than27 degrees French).we suggest using distilled or de-
mineralized water. Before using equipment, open the flap of water (14), added just the right amount
of water to the water tank (13), first is less than the MAX water level. Connect the appliance to the
power supply. Press the main switch (8) and the boiler switch(6) ,the indicator light of the master
switch (8) and the boiler switch(6) lights up to indicate that the heat transfer and the iron are switched
on. Select the desired temperature by turning the thermostat knobs(3).The colored part indicates the
steam ironing sector. It takes about 90 seconds. While the iron heating indicator light (4) goes off, the
machine is ready to deliver steam.
INSTRUCTIONS FOR UES
Cheak the manufacturer's label on the garment, and interpret the symbol on the label as follows
Publicidad
