In the dishwasher:
NOTE: Slight discoloration is possible when cleaning the grease filters in
the dishwasher. This does not affect the grease filter's functioning.
•
Do not clean extremely dirty grease filters with dishes.
•
Loosely position the grease filter in the dishwasher. The grease filters
must not be jammed in.
Replace filters and front panel before using downdraft. Be sure to
engage TABS on front panel behind EARS as shown.
CAUTION
Failure to engage tabs properly may cause chimney to jam and
fail to raise up.
To Clean By Hand:
NOTE: You can use a degreaser if soiling is stubborn. The THERMADOR
Stainless Steel Conditioner can be purchased online (US only) at: www.
thermador-eshop.com
NOTICE: The use of brand names is intended only to indicate a type
of cleaner. This does not constitute an endorsement. The omission of
any brand name cleaner does not imply its adequacy or inadequacy.
Many products are regional in distribution and can be found in the local
markets. It is imperative that all products be used in strict accordance
with instructions on the package.
Soak the grease filters in hot soapy solution using a mild
•
detergent.
Use a brush for cleaning and then rinse the filters well.
•
Allow the grease filters to drip dry.
•
Clean and dry intake housing, then reinstall or replace filters before
using downdraft.
To Clean Intake Housing:
Pull front panel up and out.
•
Remove both filters.
•
Use a mild detergent. DO NOT USE ABRASIVE CLOTH, STEEL
•
WOOL PADS, OR SCOURING POWDERS.
Clean and reinstall or replace both filters and install front panel before
using downdraft.
NOTICE: The use of brand names is intended only to indicate a type
of cleaner. This does not constitute an endorsement. The omission of
any brand name cleaner does not imply its adequacy or inadequacy.
Many products are regional in distribution and can be found in the local
markets. It is imperative that all products be used in strict accordance
with instructions on the package.
NOTE: Do not use cooktop while hood is disassembled.
Page 11
Cleaning Agents
To prevent various surfaces from becoming damaged due to incorrect
cleaning agents, follow the specifications given in the table. Do not use:
cleaning agents that are harsh or scouring,
•
cleaning agents with high alcohol content,
•
hard scouring pads or sponges,
•
high-pressure cleaners or steam cleaners.
•
Rub stainless steel finishes in the direction of the grain. Wipe area dry to
avoid water marks.
After cleaning, place all parts in their proper positions before using.
Thoroughly rinse all new sponges before use.
Observe all instructions and warnings accompanying cleaning agents.
Area
Cleaning agents
Stainless steel
Warm soapy water:
Clean with a dish rag and dry with a soft towel.
Only clean stainless steel with the grain.
Specific products for stainless steel care
are available from customer service or from
specialized retailers. Apply a thin layer of the
care product with a soft cloth.
Varnished surfaces
Warm soapy water:
Clean with a damp dish rag and dry with a soft
towel.
Do not use stainless steel cleaner.
Aluminum and
Glass cleaner:
plastic
Clean with a soft cloth.
Glass
Glass cleaner:
Clean with a soft cloth. Do not use a glass
scraper.
Controls
Warm soapy water:
Clean with a damp dish rag and dry with a soft
towel.
Risk of damage to electronics due to moisture
penetration. Never clean controls with a wet
cloth.
Do not use stainless steel cleaner.