Reloop Spin Manual De Instrucciones página 11

17. USB Rec. Port
Connect a USB storage device (USB stick) to this port, in case you would like to create a record-ing.
18. Headphones Out (3.5 & 6.3 mm Jack)
Plug in headphones with 3.5 or 6.3 mm jacks to this connection.
NOTE: When headphones are connected, the speaker will be muted.
19. Master Out (RCA)
Connect Reloop SPIN to a sound system via this connection (RCA).
NOTE: When a cable is connected to the Master Output, the speaker will be muted.
20. On/Off Button
Via this button you can turn on/off your Reloop Spin.
21. USB PSU Input
Connect a regular USB PSU (not included in the scope of delivery) to this connection and a power outlet.
22. Battery Compartment
Optionally you can operate Reloop SPIN with 2 Lithium Ion
18650 batteries. To do so, open this compartment and insert to
fully loaded batteries.
NOTE: Further information can be found in chapter "V. Opera-
tion/Power Supply" in this in-struction manual.
23. Aux In (3.5 mm Jack)
Connect your audio source to this connection via 3.5 mm jack.
24. Speaker
Your Reloop SPIN turntable disposes of an integrated 3-watts speaker for playing records, play-back devices connected to Aux-In and Bluetooth
audio signals.
NOTE: This integrated speaker will be muted when either Master Out -19- or one of the Headphones Outputs -18- is used.
IV. CROSSFADER
It is possible to replace the crossfader or install it in the alternate holder, in order to use your preferred crossfader side.
Installing the crossfader in alternate compartment
First remove the crossfader cap. Then unscrew the 2 outer
screws. The crossfader can now be pulled out of the compart-
ment. Gently remove the cable connector from its socket on the
pcb. Unscrew the 2 screws of the alternate crossfader compart-
ment and remove the cover. Now place the crossfader with its
cover into the alternate compartment and fix it with the two
screws. You will find the necessary cable for connecting the
crossfader in the compartment.
Replacing the crossfader (1)
First remove the crossfader cap. Then unscrew the 2 outer screws.
The crossfader can now be pulled out of the compartment. Gently
(1)
remove the cable connector from its socket on the pcb.
Unscrew the two screws from the crossfader cover. Replace the
crossfader and fix it with its cover by tightening all screws.
(2)
NOTE!
In both compartments you can find an additional cable (2)
which is intended for connection of third-party crossfaders
(digital).
11