Code Identification; Reset To Factory Settings - GE 24912 Manual De Instrucciones

Using Your Remote, cont.
3. Press and release the MUTE button.
4. Press and release the VOL button.

Code Identification

1. Press and hold the SETUP button
2. Press and release the desired device
3. Press and release ENTER button.
4. Press and release the #1 button.
5. Press and release ENTER button to

Reset to Factory Settings

1. Press and hold the SETUP button
2. Press and release the MUTE button.
3. Press and release the number #0
Volume Feature.
The red indicator light will blink twice
and go off.
until the red indicator stays on
(approximately 4 seconds) and then
release the button.
button (TV, DVD/VCR, CBL/SAT) you
would like the code for.
Count the number of times the
remote light flashes. This is the
number corresponding to the first
digit of the code. Repeat the process
by pressing the #2, #3 and #4
buttons for the remaining digits.
exit this mode.
until the red indicator stays on
(approximately 4 seconds) and then
release the button.
button. The red indicator light will
flash twice.
12