Troubleshooting Guide - Avanti CBC113G0WG Manual De Instrucciones

Enfriador de bebidas comercial
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

You can solve many common appliance problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Appliance does not operate.
Compressor turns on and off frequently.
Temperature inside the appliance is too warm.
The light does not work.
Appliance seems to make too much noise.
Vibrations.
PROBLEMS WITH YOUR APPLIANCE ?

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE
Not plugged in.
The circuit breaker tripped or blown fuse.
Compressor power delay is activated, this delays
the power or cycling of the compressor for (3)
three minutes after a power outage or the first
time the unit is plugged in.
The room temperature is hotter than normal.
A large amount of food has been added to the
appliance.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The appliance does not have the correct
clearances.
The appliance has recently been disconnected for
a period of time. Four hours are required for the
appliance to cool down completely.
Temperature control is set too warm. Turn the
control to a cooler setting and allow several hours
for the temperature to stabilize.
Door is kept open too long or is opened too
frequently. Warm air enters the appliance every
time the door is opened. Open the door less
often.
The door is not closed completely.
The door gasket does not seal properly.
The appliance has recently been disconnected for
a period of time. Four hours are required for the
appliance to cool down completely.
Not plugged in.
The circuit breaker tripped or a blue fuse.
The light button is OFF.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of the refrigerant in
your unit.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The appliance is not level.
Check to assure that the appliance is not on a
level surface.
Floor is uneven or weak. Appliance rocks on the
floor when it is moved slightly. Be sure floor can
adequately
support
appliance by putting wood or metal shims under
appliance.
Level
the

Publicidad

Tabla de contenido
loading

Tabla de contenido