Maintenance - Ryobi ONE+ P718 Manual Del Operador

EMPTYING/REMOVING/REATTACHING THE
DUST BOWL
See Figures 7 - 10, pages 8 - 9.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To empty:
 Remove the battery pack.
 Hold unit over waste receptacle.
 Press lock button on bottom of bowl to release spring
loaded door.
 Shake lightly or tap sides to dislodge debris.
 Close door, pressing firmly until lock button engages.
To remove:
 Remove the battery pack.
 Push the release button located on top of the hand vac.
Pull the dust bowl down and out.
This product contains no serviceable parts.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
CLEANING/REPLACING THE FILTER
See Figure 12, page 9.
 Remove the battery pack and the dust bowl.
 Remove the filter assembly by pulling it out of the dust
bowl.
NOTE: ILLUSTRATIONS START ON PAGE 7 AFTER
OPERATION

MAINTENANCE

FRENCH AND SPANISH LANGUAGE SECTIONS.
To reattach:
 Position the two sections as shown. Align the slot on the
bottom of dust bowl with the tab on the bottom of motor
housing, then snap the two sections together.
REMOVING BLOCKAGES AND CLEANING
THE ROLLER BAR
See Figure 11, page 9.
Obstructions in the roller bar may activate the overload
protection sensor and must be removed. The roller bar will
stop and the light on the roller bar will illuminate red.
To reset:
 Remove the battery pack.
 Remove the roller bar assembly from the wand or stick
vacuum base and clear any obstructions with a blunt
object.
NOTE: Use scissors to remove any threads or hair
wrapped around the roller bar.
 Wait at least 1 minute before reattaching the assembly.
 Shake or lightly brush any dust or dirt off the filter
assembly.
 Remove the prefilter by lightly pulling on one of the tabs
and lifting away from the assembly. The prefilter may be
rinsed if necessary.
 Empty the dust bowl; wash if necessary. Before reattach-
ing to the hand vac, make sure all pieces are completely
dry.
 Attach the prefilter to the filter by inserting the base of
the filter into the indent of the prefilter and snapping the
tabs into place.
NOTE: Carefully spread the tabs to help align and snap
them into place.
 Install the filter assembly into the dust bowl. Reattach
the dust bowl by aligning the slot on the bottom of dust
bowl with the tab on the bottom of motor housing, then
snap the two sections together.
When purchasing a replacement filter assembly, request
recommended part number 313282002.
6 — English