Transport And Storage; Fault Codes - Husqvarna BLi80 Manual De Instrucciones

• Retain the original product literature for future
reference.
• Use only the cell or battery in the application for which
it was intended.
• When possible, remove the battery from the
equipment when not in use.
• When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
nails, screws or other small metal objects, that
can make a connection from one terminal to
another. Shorting the battery terminals together may
cause burns or a fire.
Operation
The display shows the battery capacity and if there are
any problems with the battery. The battery capacity is
displayed for 5 seconds after the machine is switched off
or the battery indicator button is pressed. (8) The warning
symbol on the battery is lit when an error has occurred.
See fault codes. (6)
LED lights
All LEDs are lit
LED 1, LED 2, LED 3 are lit.
LED 1, LED 2 are lit.
LED 1 is lit.
LED 1 flashes.
When all the LEDs are lit on the battery, it is fully charged.
(7)
Regularly check that the battery charger and the battery
are intact.
The battery must be charged before using it the first time.
The battery is only 30% charged when delivered.
• Put the battery in the battery charger. Make sure that
the battery is connected to the battery charger. (1), (2)
• The green charging light on the charger is lit when the
battery is connected to the battery charger. (4)
• When all LEDs are lit the battery is fully charged. (7)
• Remove the battery from the battery charger. Use the
battery in surroundings where temperatures are
between -10 °C and 40 °C.
NOTE!
During charging monitoring the charging process and
never leave the battery in the charger when charging is
complete.

Transport and storage

• The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements.
• For commercial transports e.g. by third parties,
forwarding agents, special requirement on packing
and labeling must be observed.
4 – English
BATTERY HANDLING
Battery status
Fully charged (75-100%).
The battery is 50%-75%
charged.
The battery is 25%-50%
charged.
The battery is 0%-25%
charged.
The battery is empty.
Charge the battery.
• For preparation of the item being shipped, consulting
an expert for hazardous material is required. Please
also observe possibly more detailed national
regulations.
• Tape or mask off open contacts and pack up the
batteriy in such a manner that it cannot move around
in the packing.
• Store the equipment in a lockable area so that it is out
of reach of children and unauthorized persons.
• Store the battery and the battery charger in a dry,
moisture-free and frost-free space.
• Store the battery where the temperature is between 5
°C and 25 °C and never in direct sunlight.
• Be sure to store the battery separate from the battery
charger.
• Do not store the battery in places where static
electricity can occur. Never store the battery in a metal
box.
• Before longer storage please charge the battery.
Maintenance
Make sure the battery and battery charger are clean and
that the terminals on the battery and the battery charger
are always clean and dry before the battery is placed in
the battery charger.
Keep the battery guide tracks clean. Clean plastic parts
with a clean and dry cloth.

Fault codes

Troubleshooting the battery and/or the battery charger
during charging. (5), (6)
Possible
LED display
faults
Temperatur
e deviation.
Error LED
flashing
Over
voltage.
Under
voltage
Cell
difference
Error LED is lit
too much
(1V).
• The battery will not be charged if the battery
temperature is over 50 °C. In that case the battery
charger will actively cool down the battery.
• If the LED on the battery charger is lit solid red, the
battery charger requires a service.
Possible action
Use the battery in
surroundings where
temperatures are
between -10 °C and 40
°C.
Check that the mains
voltage corresponds
with that stated on the
rating plate on the
machine.
Remove the battery
from the battery
charger.
Charging the battery
Contact your service
agent.