General Safety Information - Hydromatic HCU Serie Manual Del Propietário

Safety
READ ALL INSTRUCTIONS
BEFORE STARTING INSTALLATION

General Safety Information

Electrically powered condensate pumps normally give
many years of trouble-free service when correctly installed,
maintained, and used. However, unusual circumstances
(interruption of power to the pump, algae/debris in the
reservoir, electrical or mechanical failure in the pump,
etc.), may prevent your pump from functioning normally.
Consequently, any condensate pump installed in an area
susceptible to water damage must be connected to a failure
alarm or water sensing device or include an auxiliary safety
shutoff switch activated by high water in the pump reser-
voir and connected to the thermostat of the furnace/AC
unit. See the "Troubleshooting Chart" in this manual for
information about common condensate pump problems.
For more information, see your dealer or call customer
service at 1-888-957-8677.
1. Drain all water from system before servicing.
2. Periodically inspect reservoir, pump, and system com-
ponents. Keep free of debris and foreign objects.
Perform routine maintenance as required.
3. When installing an electrically driven pump, follow all
electrical and safety codes that apply.
4. Make certain power source conforms to requirements
of your equipment.
HYDROMATIC warrants to the original consumer purchaser ("Purchaser" or "You") of HYDROMATIC Sump Pumps, Effluent
Pumps, Sewage Pumps (other than 2-1/2"), and Package Systems, that they will be free from defects in material and
workmanship for the Warranty Period of 36 months from date of manufacture.
Our warranty will not apply to any product that, in our sole judgement, has been subject to negligence, misapplication,
improper installation, or improper maintenance. Without limiting the foregoing, operating a three phase motor with single
phase power through a phase converter will void the warranty. Note also that three phase motors must be protected by
three-leg, ambient compensated, extra-quick trip overload relays of the recommended size or the warranty is void.
Your only remedy, and HYDROMATIC's only duty, is that HYDROMATIC repair or replace defective products (at
HYDROMATIC's choice). You must pay all labor and shipping charges associated with this warranty and must request
warranty service through the installing dealer as soon as a problem is discovered. No request for service will be accepted
if received after the Warranty Period has expired. This warranty is not transferable.
EXCEPTIONS: Hydromatic Special Application Pumps, Battery Back-Up Sump Pumps, Filtered Effluent Pumps, Grinder
Pumps, and 2-1/2" Sewage Pumps are warranted for a period of 12 months from date of purchase or 18 months from
date of manufacture, whichever comes first.
HYDROMATIC SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, OR CONTINGENT DAMAGES
WHATSOEVER.
THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS AND IMPLIED
WARRANTIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE. THE FOREGOING WARRANTIES SHALL NOT EXTEND BEYOND THE
DURATION EXPRESSLY PROVIDED HEREIN.
Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on the duration
of an implied warranty, so the above limitations or exclusions may not apply to You. This warranty gives You specific legal
rights and You may also have other rights which vary from state to state.
This warranty supersedes and replaces all previous warranty publications.
Phone: 888-957-8677 • Fax: 888-840-7867 • Web Site: http://www.hydromatic.com
LIMITED WARRANTY
HYDROMATIC
740 East 9th Street, Ashland, OH 44805
5. Protect electrical cord from sharp objects, hot surfaces,
oil, and chemicals. Avoid kinking cord. Replace or
repair damaged or worn cords immediately.
6. Personal Safety:
a. Wear safety glasses at all times when working with
pumps.
b. Keep work area clean, uncluttered and properly
lighted – replace all unused tools and equipment.
c. Keep visitors at a safe distance from work area.
d. Make workshop child-proof – with padlocks, master
switches, and by removing starter keys.
Risk of electric shock. If your basement has
water or moisture on floor, do not walk on wet area until
all power has been turned off. If shut-off box is in base-
ment, call electric company to shut-off service to house,
or call your local fire department for instructions. Failure
to follow this warning can result in fatal electrical shock.
When pump is plugged in, do not handle pump, cord, or
plug with wet hands or when standing on a wet or damp
surface or in water. Unplug pump before servicing it or
doing any maintenance on it.
2