Bimar VP309 Folleto De Instrucciones página 17

4) Insert the rear grid (19) onto the motor shaft (20), so that
the handle is at the top (like in the figure to the side),
securing it using the 4 screws provided (18.)
5) Insert fan (16) onto the motor shaft (20) and attach it so
that the screw (17) touches the milling formed on the motor
shaft (like in the figure), (at the end of the work, check that
the fan is correctly secured).
5) Couple the front grid (15) with the rear grid (19) and lock with the retention
hooks. For safety reasons, you must ensure the fastening with the
appropriate locking screw (14) in the holes provided on the edge of the grid,
(the screw holes must be in the lower part).
USE
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer
or a competent qualified electrician or a person with similar qualifications, in
order to avoid any risk.
Insert the plug of the fan in the power supply.
Ventilation: select the desired speed by turning the switch (7) to one of the
following positions:
I– Minimum speed I I–Medium speed I I I–Maximum speed
To turn off, turn the switch to position 0 and then remove the plug from the
socket.
Horizontal oscillation (right-left): this is selected with the button (13) located on
the motor body. To stop the motion and keep the ventilator still, press the
button.
Vertical inclination (high-low): it is regulated by gripping the motor body and
orienting it in the direction desired; tighten the screw (10) to lock the motor
housing to the desired position.
When not in use for long periods, the plug must always be removed from the
socket.
CLEANING AND MAINTENANCE
Attention: before normal cleaning, remove the plug from the socket.
 Clean the body with soft, slightly damp, cloth; do not use abrasive or corrosive
products.
 Do not immerse any part of the fan in water or other liquid: if this should happen,
do not put your hand in the liquid, but first remove the plug from the socket.
17/48