Vivanco PA 115 Manual De Instrucciones página 5

BDA 30338_Layout 1 01.07.11 09:53 Seite 5
Troubleshooting
Problem
Bad or
no reproduction
Technical data:
Phono Preamplifier
Input voltage:
Signal input:
Signal output:
Power supply
Input voltage:
Output voltage:
Output current:
Stand-by consumption:
Operating temperature:
Hereby Vivanco GmbH declares that PA 115 is in conformity with the fundamental requirements
and other relevant regulations of the directive 2004/108/EU.
Disposal of the device
This device may not be disposed along with household waste. Please hand it over to a
collection point for electrical devices of your area or your district. Thus it will be guaranteed
that the old devices are recycled properly and economically and potential environmental and
health hazards are avoided.
The packing should be supplied to re-use. Please do not throw it into household waste and
handle it in conformity with local disposal rules.
Possible cause
Preamplifier is not connected with
a current supply
Record player or reproduction
device (for example audio
receiver, amplifier or PC) are not
switched on
Cable connection broken
Volume on the reproduction
device (for example mixing desk,
amplifier or PC) is switched off or
too low
12V
2 x Cinch
2 x Cinch
100-240V~ 50-60Hz, Euro plug
12V
100mA
<0,3W
5...35°C
Solution
Ensure power supply
Switch on all connected
devices
Check if all the plug
connections are plugged in
properly
Increase volume
GB
5