Tripp-Lite APS Serie El Manual Del Propietario página 9

Mounting
WARNING! Mount your Inverter/Charger BEFORE DC battery and AC power
connection. Failure to follow these instructions may lead to personal injury
and/or damage to the Inverter/Charger and connected systems.
Tripp Lite manufactures a variety of different Inverter/Chargers with a variety of different mounting options for use in vehicular or non-vehicular
applications. Tripp Lite recommends permanent mounting of your Inverter/Charger in any of the configurations illustrated below. User must
supply mounting hardware and is responsible for determining if the hardware and mounting surface are suitable to support the weight of the
Inverter/Charger. Contact Tripp Lite if you require further assistance in mounting your Inverter/Charger.
Vehicular and Non-Vehicular Horizontal Mount
(612, 750 and 1250 models only)
Using the measurements from the diagram, install two user-sup-
A
plied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving
the heads slightly raised.
B
the fasteners to engage the mounting slots molded on the bottom of
the Inverter/Charger cabinet.
plied ¼" (6 mm) fasteners into the mounting feet molded on the
front of the Inverter/Charger cabinet.
C
Vehicular and Non-Vehicular
(All models except 612, 750 and 1250)
• Horizontal Mount • Vertical Mount • Inverted Mount
Tripp Lite's Lateral Mounting Bracket (pre-installed on select models, but also
available as an optional accessory from Tripp Lite*) provides a rigid surface
for lateral mounting in vehicular or non-vehicular applications. Consult the
instructions packed with the Lateral Mounting Bracket for complete mounting
information. Note: your Inverter/Charger is not designed nor covered under
warranty for vertical or inverted mounting in a vehicular application. Such
mounting may be possible, however, when your Inverter/Charger is properly
secured to a Lateral Mounting Bracket. As with any mounting, user is respon-
sible for determining if the Inverter/Charger can be mounted safely relative to
their application. Since securing an Inverter/Charger to a Lateral Mounting
Bracket which is not factory pre-installed will require some modifications to
the Inverter/Charger cabinet, please consult the Lateral Mounting Bracket
owner's manual (available online at www.tripplite.com) prior to purchasing.
* Contact Tripp Lite for ordering information.
Lateral Mounting Bracket
Slide the Inverter/Charger back over
Install and tighten two user-sup-
C
A
B
Vehicular and Non-Vehicular Horizontal Mount
and Non-Vehicular Vertical Mount
(All models except 612, 750, 1250 and 3624)
Using the measurements from the diagram, install two user-sup-
A
plied ¼" (6 mm) fasteners into a rigid surface, leaving the heads
slightly raised.
B
fasteners to engage the mounting feet molded on the front of the
Inverter/Charger cabinet.
¼" (6 mm) fasteners into the mounting feet molded on the rear
of the Inverter/Charger cabinet. The rear feet extend beyond the
unit's cabinet to provide for adequate ventilation space behind the
cooling fan(s); they should not be removed.
A
Note: APS model cabinets may have different front panel features, but all have identical mounting. Vertical Mount for select
models only.
9A
Slide the Inverter/Charger forward over the
Install and tighten two user-supplied
C
C
B
C
B
A