Tabla de contenido
Publicidad
FIGURE 1.
MOUNTING AND WIRING INSTRUCTIONS
GB
NOTE: Line art shown may not exactly match the fixture enclosed. However, the installation
instructions do apply to this fixture.
The light source of this luminaire is not replaceable; when the light source reaches its end
of life the whole luminaire shall be replaced.
CAUTION: For fixtures labeled for outdoor and wet location use, provide a water-tight seal
between the fixture and the mounting surface by using silicone or similar caulking.
1. Turn off power at circuit box to avoid possible electric shock.
2. Place universal mounting plate (B) flush against wall at desired mounting location.
Using outside mounting bar holes as a guide, mark where pilot holes are to be drilled.
NOTE: Universal mounting plate (B) must be level for fixture to hang straight.
3. Inset 4 plastic anchors (D) into the pilot holes (for drywall).
4. Align outside universal mounting plate holes with plastic anchors (D) (If applicable).
Secure universal mounting plate (B) into place using wood screws (E).
5. Make an electrical connection by loosening the terminal screws on the terminal block (F)
and inserting the live, neutral and ground terminals.
6. Tighten terminal screws. Make sure there are no stray wires.
7. Position back plate (B) over universal mount plate (C) by aligning back plate openings
on edges on back plate with the screw holes on universal mounting plate (C).
8. Replace screws (D) onto the edge of back plate (B).
9. Turn power back on at circuit box.
GS-26-FS09-WH18
F
B
D
E
G
A
19
Publicidad
Tabla de contenido
