HAMPTON BAY 25-791-68-Y Guía De Uso Y Cuidado página 11

Operation (continued)
The infrared remote control relies on a line of sight and must be pointed at the controls of the log set to work. The remote control unit
has the controls required to turn ON/OFF both the main power and the heater. If you prefer to use the control buttons on the log set unit
itself, they are on the lower right corner of the unit. The layout of the buttons and remote control unit can be seen in Figures 2 and 3,
respectively.
□ Plug your log set into a 15-amp, 120-volt power outlet.
□ Turn the power on. Flame will show on the wall behind the log set.
□ Remove the plastic tab from inside the battery compartment
to activate the remote control.
□ Point the remote control directly at the control buttons of the log set and
use the buttons to operate the
log set.
2
Using the Remote Control
1. Main Power Button: This button supplies power to all the functions of
the electric fireplace. The main power button must be in the ON position,
either from the remote or the controls on the electric fireplace for the
functions to work.
2. Heater Control Button: This button controls the heater ON/OFF and 5
temperature modes from Low to High. When the heater is first turned on,
the heater will come on at the lowest room temperature setting. The log
set will remember the last heat setting. In later use, the heater will start
at that setting, unless power to the unit has been interrupted. Each time
this button is pressed, the temperature set point increases, allowing you
to adjust the ambient temperature.
3. Flame Control Button: This button controls the brightness of the flame
effect with settings at High, Medium and Low. When the log set is first
turned on, the flame will come on at the highest setting. The log set will
remember the last flame setting used. In later use, the flame brightness
will start at that setting, unless power to the unit has been interrupted.
Each time the Flame button is pressed, the flame brightness decreases.
The only way to turn off the flame effect completely is to turn off the
Main Power button.
Battery Replacement Procedure: (Size CR2025)
Battery replacement instruction
CR2025
RELEASE
OPEN
PUSH
1
2
3
IMPORTANT: Under normal operation, when power is interrupted from either an
outage or from unplugging unit from wall while still in operation, the heat level
indicator lights may blink repeatedly and the unit will cease operation. In order to
reset the unit, unplug for 10 minutes, then plug back in and operate normally in
accordance with the Use and Care Guide.
11
PLEASE CONTACT 855-HD-HAMPTON FOR FURTHER ASSISTANCE.
The plastic tab inside the battery
compartment MUST be removed
before the remote control will operate.
(Pull tab)
Figure 3
HAMPTONBAY.COM