Craftsman 917.20384 Manual Del Operador página 24

TO LEVEL MOWER
Ensure tires are properly inflated to the PSI
shown on tires. If tires are over or under
inflated, it may affect the appearance of your
lawn and lead you to think the mower is not
adjusted properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT
1. With all tires properly inflated and if your
lawn appears unevenly cut, determine
which side of mower is cutting lower.
2. With a 3/4" or adjustable wrench, turn
lift link adjustment nut (A) to the left to
lower LH side of mower, or, to the right
to raise LH side of mower.
Turn nut
right to
raise
mower
NOTE: Each full turn of adjustment nut will
change mower height about 3/16" (4,7 mm).
3. Test your adjustment by mowing some
uncut grass and visually checking the
appearance. Readjust, if necessary, until
you are satisfied with the results.
PRECISION SIDE-TO-SIDE ADJUSTMENT
1. With all tires properly inflated, park tractor
on level ground or driveway.
CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap blade
with heavy cloth.
2. Raise mower to its highest position.
3. At both sides of mower, position blade
at side and measure distance "A" from
bottom edge of blade to ground. The dis-
tance should be the same on both sides.
4. If adjustment is necessary, see steps in
Visual Adjustment instructions above.
5. Recheck measurements; adjust if neces-
sary until both sides are equal.
A
A
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-
to-side.
To obtain the best cutting re sults, the mower
blades should be adjusted so the front tip
is 1/8 to 1/2" (3,1 to 12,7 mm) (lower than
the rear tip when the mower is in its highest
position.
CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap blade
with heavy cloth.
• Raise mower to highest position.
• Position any blade so the tip is pointing
straight forward. Measure distance "B" to
the ground at front and rear tip of blade.
• If front tip of blade is not 1/8 to 1/2" (3,1
to 12,7 mm) lower than the rear tip, go to
the front of tractor.
• With an 11/16" or adjustable wrench,
Turn nut
loosen jam nut "A" several turns to clear
left to
adjustment nut "B".
lower
• With a 3/4" or adjustable wrench, turn
mower
front link adjustment nut "B" clockwise ( )
(tighten) to raise the front of mower, or,
counterclockwise ( ) (loosen) to lower
the front mower.
Tighten adjust
nut "B" to
raise mower
NOTE: Each full turn of adjustment nut will
change mower height about 1/8" (3,1 mm).
• Recheck measurements, adjust if neces-
sary until front tip of blade is 1/8 to 1/2"
(3,1 to 12,7 mm) lower than the rear tip.
• Hold adjustment nut in position with
wrench and tighten jam nut securely
against adjustment nut.
A
24
B
B
02950
Loosen jam nut "A" first
B
A
Loosen adjust
nut "B" to
lower mower