Craftsman 917.20383 Manual Del Usuario página 27

TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Remove bulb hold er from the hole in the
back side of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in the
backside of the grill.
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-
in fuse. The fuse holder is located behind
the dash.
TO REMOVE HOOD & GRILL AS SEM BLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Remove retainer clip and washer from
right hand pivot pin.
4. Stand in front of tractor. Grasp hood at
sides and slide left removing hood from
pivot pins and lift hood off of tractor.
5. When replacing hood, reconnect the
headlight wire con nec tor, and reinstall
the washer and retainer clip on the
right hand pivot pin.
04031
Headlight Wire
Connector
Hood
Left Pivot Pin
Washer
Retainer
Clip
Right Pivot
Pin
TRANSMISSION REMOVAL/
RE PLACE MENT
Should your transmission require re mov al for
service or re place ment, it should be purged
after reinstallation and before operating the
tractor. See "PURGE TRANS MIS SION" in
the Operation sec tion of this manual.
ENGINE
TO AD JUST THROTTLE CON TROL
CABLE
The throttle control has been preset at
the factory and ad just ment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is nec es sary, see engine manual.
TO AD JUST CHOKE CON TROL
The choke control has been preset at the
factory and ad just ment should not be neces-
sary. If adjustment is necessary, see engine
manual.
27