Before Returning For Repairs - Schumacher Electric SE-4020-CA Manual Del Usuario

PROBLEM
Engine start does
not work.

14. BEFORE RETURNING FOR REPAIRS

If these solutions do not eliminate the problem, or for more information
about troubleshooting, contact customer service for assistance:
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO NOT SHIP
UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION (RMA) number from
Customer Service at Schumacher Electric Corporation.
15. SPECIFICATIONS
Input .................................... 120V AC, 60Hz, 10A max. continuous; 48A max. intermittent
Output .......................................... 2A continuous @ 6V DC, 40A continuous @ 6/12V DC
16. LIMITED WARRANTY
WARRANTY NOT VALID IN MEXICO.
SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE,
MOUNT PROSPECT, IL 60056-2179, MAKES THIS LIMITED WARRANTY TO THE
ORIGINAL RETAIL PURCHASER OF THIS PRODUCT. THIS LIMITED WARRANTY
IS NOT TRANSFERABLE OR ASSIGNABLE.
Schumacher Electric Corporation (the "Manufacturer") warrants this battery charger
for three (3) years from the date of purchase at retail against defective material
or workmanship that may occur under normal use and care. If your unit is not free from
defective material or workmanship, Manufacturer's obligation under this warranty is
solely to repair or replace your product with a new or reconditioned unit at the option
of the Manufacturer. It is the obligation of the purchaser to forward the unit, along with
proof of purchase and mailing charges prepaid to the Manufacturer or its authorized
representatives in order for repair or replacement to occur.
POSSIBLE CAUSE
Drawing more than 200 amps.
Failure to wait 3 minutes (180
seconds) between cranks.
The charger may be
overheated.
Battery may be severely
discharged.
services@schumacherelectric.com
www.batterychargers.com
or call 1-800-621-5485
Monday-Friday 7:00
6A<>2A @ 12V DC (60 sec. @ 6A, 120 sec. @ 2A)
200A @ 12V DC intermittent (5 sec. max. on, 240 sec. min. off)
• 10 •
REASON/SOLUTION
Crank time varies with the
amount of current drawn. If
cranking draws more than 200
amps, crank time may be less
than 5 seconds.
When the Engine Start LED
blinks, wait 3 minutes of rest time
before the next crank.
The thermal protector may have
tripped and needs a little longer to
reset. Make sure the charger vents
are not blocked. Wait and try again.
On a severely discharged battery,
use the Boost rate for 10 to 15
minutes, to help assist in cranking.
to 5:00 CST
am pm