Lenco LBT-188 Manual De Usuario página 8

Please check thoroughly and make sure you find the following items that
come along with this package:
1) Unit
2) Adaptor with EU-UK plug-end
3) Counterweight
4) Platter with Belt
5) 45 RPM Adaptor
6) Turntable mat
This turntable is supplied with a factory fitted and adjusted cartridge.
**The following instructions for adjusting the cartridge are provided in case
the cartridge is replaced by a different model at a later date.
Installing the Lid
Install the Lid carefully over the hinge prongs.
Turntable Platter and Belt Setup
1. Install the drive belt over the inner ring under the platter and make
sure it won't fall off during the setup.
2. Place the platter through the turntable
spindle, then rotate the platter until you see
the drive motor pulley through the window at
the top left corner.
3. Carefully grab the drive belt and put it
around the slot of motor pulley.
4. Connect the power adapter to the turntable and power on the
turntable.
5. Set the Motor Start/Stop switch to the Start position to see if the
platter motor spins. If the platter does not spin, try the steps listed
above again.
7) Instruction Manual
8) Cartridge Alignment Protractor
9) USB-PC Cable
10) 2pcs lid spare rubber
11) Anti-skating Weight
7