Victron energy SmartSolar MPPT 100/30 Manual De Instrucciones página 10

On all models with software version V 1.12 or higher a binary
LED code helps determining the position of the rotary switch.
After changing the position of the rotary switch, the LEDs will
blink during 4 seconds as follows:
Switch
position
0
1
2
3
4
5
6
7
Thereafter, normal indication resumes, as described below.
Remark: the blink function is enabled only when PV power is
present on the input of the controller.
3.6 LEDs
LED indication:
 permanent on
 blinking
 off
Regular operation
Bulk (*1)
Absorption (*2)
Automatic equalisation (*2)
Float (*2)
Note (*1): The bulk LED will blink briefly every 3 seconds when the system is powered but
there is insufficient power to start charging.
Note (*2): The LED(s) might blink every 4 seconds indicating that the charger is receiving
data from another device, this can be:
• A GX Device (eg Color Control with a Multi in ESS mode)
• A VE.Smart network link via Bluetooth (with other MPPT chargers and / or a
BMV or Smart Battery Sense)
Fault situations
Charger temperature too high
Charger over-current
Charger or PV over-voltage
Internal error (*3)
Note (*3): E.g. calibration and/or settings data lost, current sensor issue.
8
LED LED
Bulk Abs
1 1
0 0
0 1
0 1
1 0
1 0
1 1
1 1
LEDs
LEDs
LED
Float frequency
1
1
0
1
0
1
0
1
Bulk Absorption
 
 
 
 
Bulk Absorption
 
 
 
 
Blink
Fast
Slow
Slow
Slow
Slow
Slow
Slow
Slow
Float




Float



