Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS.
1. Front cover.
2. Front cover screws.
3. Front grille.
4. Blade clamping nut.
5. Blades.
6. Rear grille clamp nut.
7. Rear grill.
ASSEMBLY.
- Insert the motor body into the inner tube (13) of the extensible mast.
- Tighten the nut (11) fixing the body to the mast.
- Insert the rear grill by matching the guides through the central holes of the grid.
- Fit the rear grill retaining nut (6) and tighten.
- Insert the blades (5) into the motor shaft (8).
- Fit the blade retaining nut (4) and tighten.
- On the front grill (3), put the front cover (1) and fix it with its screws (2).
- Place the front grill (3) matching the position with the rear grill.
- Close the front grille tabs so that it is attached to the rear grille (7).
NOTE.
Each of the pieces of the photos in this section may be subject to small
variations in the model of the piece.
In any case they are mounted in the same way and following the same steps.
PART 2:
FAN BODY.
8. Motor shaft.
9. Motor housing.
10. Swing button.
11. Screw fixing to the mast.
12. Electric power cable.
13. Extensible mast tube (7).
Publicidad
