Publicidad
Idiomas disponibles
Idiomas disponibles
3.
The rope guide is attached
to the right side of the upper
handle. See Fig. 3-3. Loosen the wing
nut which secures the
rope guide.
1.
2.
3.
4.
Place rear of the mower deck on raised blocks.
Remove lock nut from pivot arm assembly
(on select
models,
these may be included
separately
in a plastic bag).
Slide wheel, with hollow
side in, onto pivot arm and secure
with lock nut.
Assemble the other side in the same manner.
GrassCatcher
Follow steps below to assemble
the grass catcher. Make
certain
bag is turned
right side out before assembling
(warning
label will be on the outside).
a.
Place bag over frame so that its black plastic side is
at the bottom.
b.
Slip plastic channel
of grass bag over hooks on the
frame. See Fig. 3-5. All the plastic channels
except
center top of bag attach from outside
of bag.
Figure
3-3
a.
Hold blade control
against
upper handle.
b.
Pull starter rope out of the engine.
Release blade
control.
c.
Slip starter rope into rope guide.
d.
Tighten
wing nut.
4.
Insert post on cable tie into hole provided
on the lower
handle. Pull cable tie tight and trim excess.
RearWheels
Install rear wheels as follows
in Fig. 3-4 (wheels maybe already
installed
at factory,
if so disregard
this step):
\
Figure 3-4
Figure
3-5
c.
Attach center top of bag from inside of bag.
SECTION
3 -- ASSEMBLY& SET-UP
9
Publicidad
