1. FEATURES
MODEL
CM1624TB (Black)
CM1624TS (Silver)
•
200 Watts music peak power
•
80 Watts continuous power
•
6.5" (165mm) IMPP Woofer Cone
•
1" (25mm) PEI Dome Tweeter
•
Built-In RGB LED Illumination
•
Carbon Fiber Spoke Design
360 Degree Swivel Bar Clamp and Surface Mount
•
•
Bar mount adjustable to fit 1.5", 1.75", 2", 2.5", 2.75" bar sizes
•
High Impact ASA Enclosure
•
Water resistant, IP55 ingress protection
•
Meets or exceeds ASTM B117 (Salt Fog exposure)
•
Meets or exceeds ASTM D4329 (UV exposure)
•
Stainless Steel Mounting Hardware Included
•
Optional All Weather Protective Cover (CM1624TPC)
2. PRECAUTIONS
1. Be sure to carefully read and understand the instructions before attempting to install these
speakers.
2. For safety, disconnect the negative battery terminal from the battery prior to starting the installation.
3. For easier assembly, we suggest you have all your tools handy:
Drill, Allen Wrench Set, Wire Crimpers, Soldering Iron, Wire Strippers, Heat Shrink Tubing, etc.
4. Use high quality, waterproof connectors for a reliable installation and to minimize signal or power
loss.
5. Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic
lines, vacuum lines, electrical wiring, or drilling through the hull when working on any boat.
6. If possible, do not run wires near fuel lines or power. Running the wires inside the hull area
provides the best protection.
7. Avoid running wires over or through sharp edges. Use rubber or plastic grommets to protect any
wires routed through metal - especially the tower/T-Tops.
8. Make sure the mounting clamps are tight before leaving the dock or cruising off-road.
TYPE
6.5" (165mm) 2-Way Marine
Tower Speakers
POWER HANDLING
80W Continuous Power
CM1624TB / CM1624TS
3