Midwest Pet Gate 2929SW-GL Manual Del Usuario página 4

If you intend to use the optional drywall anchors, drill a
pilot hole and insert the anchors into the center of
each marked circle. (Refer to illustration a/b for use
with anchors and illustration c for use without drywall
anchors.)
NOTE: The adhesive mounting pads are included only
for positioning the mounting cups and must be used in
conjunction with screws.
Remove the liner from one side of the adhesive
mounting pads, then place and stick a pad inside each
of the four pencil-marked circles. Remove the other
liner from each mounting pad and place the mounting
cups on each pad. Fasten the mounting cups to the
wall using the screws included in the hardware bag.
Installing the Gate in the Opening
4. Begin by positioning the gate level and centered in the
doorway opening. NOTE: It is important to install the
gate with a spacing of no more than 0.196" from the
floor, and to make sure the gap between the side walls
and the gate is no more than 2.5" on each side of the
gate.
Pull the 4 threaded spindle bolts out of the ends of the
frame tubes until the pad touches the wall. **If you are
using the mounting cups, the pads should go into the
mounting cups that are fastened to your wall.**
5. While holding the pad against the wall, turn the
metal nut counter clockwise until the nut is up against
the end of the frame as shown. DO NOT TIGHTEN.
Go to step 6 for final adjustment. HELPFUL HINT: In
might be necessary to hold the threaded spindle bolt
while turning the nut to ensure the threaded spindle
bolt doesn't turn.
4